Folding Grass Fork

+

The Prodig Folding Grass Fork is designed to handle the increased output from a new generation of high capacity silage harvesters. Our fork is designed to withstand the rigorous demands of today’s busy contractor with clever designs to reduce down time.

  • Designed for use on Large Wheel Loaders.
  • Heavy duty construction using High Yield structural hollow section and plate.
  • Available in widths from 3675mm to 4880mm.
  • 1525mm square profile Hardox tines used in bottom bar for long service life.
  • Our full range of Hardox tines are manufactured incorporating a replaceable wear tip meaning the tine never has to be replaced.
  • 60mm pivot point pin fitted with replaceable hardened bushings.
  • Hardened cutting edge full length of bottom section.
  • Fitted with Hydraulic accumulator and ram cushioning to increase pivot point lifespan.
  • Side wings can be locked in closed position for safe road transport.
  • Double acting hydraulic ram on each wing.
  • Greasable bushings on all pivot points.

 

 

  1. Fitted with Hydraulic accumulator and buffer pads as standard.
  2. Side wings can be locked in closed position for transport.
  3. Bushings and grease points on all pivot points.
  4. 60mm pivot point pin fitted with replaceable bushings.
  5. 50mm Hardox steel by 1.525m (5ft) tines used in bottom bar for long service life.
  6. Hardened cutting edge full length of bottom section.

Grass Forks 12FT 14FT 16FT
Height (mm) 1675 1675 11845
Width Open (mm) 3675mm (12FT) 4235MM (14FT) 4880MM (16FT)
Width Closed (mm) 2567mm (8FT 5') 2567mm (8FT 5') 2567mm (8FT 5')
Depth (mm) 1850 1850 1850
Weight (kg) 1300 1450 1550
Tine lenght 1525mm (5ft) 1525mm (5ft) 1525mm (5ft)
Tine width 50mm Hardox 50mm Hardox 50mm Hardox
Number of bottom Tines 14 16 18
Tine Spacing (mm) 237 237 220
Ram 2 x 70mm Bore 2 x 70mm Bore 2 x 70mm Bore

 All measurements approx (±5mm, ±5kg)
Weight excludes brackets as these vary

 

Ask about this product